Re: cdrecord and 'invalid field in parameter list' error

From: Nathan Neulinger (nneul@umr.edu)
Date: Sat Sep 23 2000 - 18:33:48 EDT

  • Next message: Jens Axboe: "Re: cdrecord and 'invalid field in parameter list' error"

    Thomas Molina wrote:
    >
    > On Sat, 23 Sep 2000, Nathan Neulinger wrote:
    >
    > > I've seen mentions of this problem before on linux-kernel and on
    > > numerous other lists, but have never seen a solution to it.
    > >
    > > Basically, when attempting to write a disk with any version of cdrecord,
    > > I get this error. I am running 2.2.17 (also 2.2.16) on x86 with
    > > hedrick's ide patch, and the reiserfs patch, and the replacement SG
    > > driver from the cdrecord page.
    >
    > Check and replace data cables, ensure power line is plugged in and good,
    > use a lens cleaner. Otherwise you may have a drive going bad, but I
    > doubt that.

    Ah... Perhaps I should have mentioned that the drive works just fine
    reading. I.e. I can pull 100MB files off cd's on that drive without any
    errors occurring. I would think that would negate any of the above
    suggestions. I do know that the drive/case is quite warm, but I wouldn't
    think that would yield such a repeatable error.

    -- Nathan

    ------------------------------------------------------------
    Nathan Neulinger EMail: nneul@umr.edu
    University of Missouri - Rolla Phone: (573) 341-4841
    CIS - Systems Programming Fax: (573) 341-4216
    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    Please read the FAQ at http://www.tux.org/lkml/



    This archive was generated by hypermail 2b29 : Sat Sep 23 2000 - 18:36:08 EDT