I'm having problems with 2.4.2-pre3 and IRQ conflicts. Last kernel that
I tried and worked without conflict was 2.4.0-test11. Here are the
relevant messages that I get:
Linux version 2.4.2-pre3 (root@neriak) (gcc version egcs-2.91.66
19990314/Linux (egcs-1.1.2 release)) #1 Sat Feb 10 11:13:59 EST 2001
PCI: PCI BIOS revision 2.10 entry at 0xfb4d0, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
Scanning bus 00
Found 00:00 [1106/0597] 000600 00
Found 00:08 [1106/8598] 000604 01
Found 00:38 [1106/0586] 000601 00
Found 00:39 [1106/0571] 000101 00
Found 00:3b [1106/3040] 000604 00
PCI: 00:07.3: class 604 doesn't match header type 00. Ignoring class.
Found 00:40 [102b/0519] 000300 00
Found 00:48 [1113/1211] 000200 00
Found 00:50 [10ec/8139] 000200 00
Fixups for bus 00
Scanning behind PCI bridge 00:01.0, config 010100, pass 0
Scanning bus 01
Fixups for bus 01
Unknown bridge resource 1: assuming transparent
Unknown bridge resource 2: assuming transparent
Bus scan for 01 returning with max=01
Scanning behind PCI bridge 00:01.0, config 010100, pass 1
Bus scan for 00 returning with max=01
PCI: Using IRQ router VIA [1106/0586] at 00:07.0
Activating ISA DMA hang workarounds.
isapnp: Scanning for Pnp cards...
isapnp: SB audio device quirk - increasing port range
isapnp: AWE32 quirk - adding two ports
isapnp: Card 'Creative SB32 PnP'
isapnp: Card 'Rockwell K56Flex Plug & Play Modem'
isapnp: 2 Plug & Play cards detected total
DMI 2.1 present.
25 structures occupying 843 bytes.
DMI table at 0x000F0800.
BIOS Vendor: Award Software International, Inc.
BIOS Version: 4.51 PG
BIOS Release: 02/26/99
System Vendor: System Manufacturer.
Product Name: Product Name.
Version SYS-xxxxxx.
Serial Number Serial Number xxxxxx.
Board Vendor: First International Computer, Inc..
Board Name: PA-2013.
Board Version: PCB 2.X.
Asset Tag: Asset Tag Number xxxxxx.
8139too Fast Ethernet driver 0.9.13 loaded
PCI: Found IRQ 11 for device 00:09.0
eth0: SMC1211TX EZCard 10/100 (RealTek RTL8139) at 0xc4800000,
00:e0:29:6e:11:da, IRQ 11
PCI: Found IRQ 10 for device 00:0a.0
IRQ routing conflict in pirq table for device 00:0a.0
eth1: RealTek RTL8139 Fast Ethernet at 0xc4802000, 00:48:54:67:17:e9,
IRQ 5
Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996
sb: Creative SB32 PnP detected
sb: ISAPnP reports 'Creative SB32 PnP' at i/o 0x220, irq 9, dma 1, 5
sb: Interrupt test on IRQ9 failed - Probable IRQ conflict
sb: 1 Soundblaster PnP card(s) found.
ISAPnP reports AWE32 WaveTable at i/o 0x620
<SoundBlaster EMU8000 (RAM2048k)>
Sound: DMA (output) timed out - IRQ/DRQ config error?
00:00.0 Host bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3] (rev
04)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
Latency: 16 set
Region 0: Memory at e0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 1.0
Status: RQ=7 SBA+ 64bit- FW- Rate=x1,x2
Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3 AGP]
(prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0 set
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 0000c000-0000cfff
BridgeCtl: Parity- SERR- NoISA+ VGA- MAbort- >Reset- FastB2B-
00:07.0 ISA bridge: VIA Technologies, Inc. VT82C586/A/B PCI-to-ISA
[Apollo VP] (rev 47)
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0 set
00:07.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev
06) (prog-if 8a [Master SecP PriP])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 set
Region 4: I/O ports at e400 [size=16]
00:07.3 PCI bridge: VIA Technologies, Inc. VT82C586B ACPI (rev 10)
(prog-if 00 [Normal decode])
!!! Header type 00 doesn't match class code 0604
00:08.0 VGA compatible controller: Matrox Graphics, Inc. MGA 2064W
[Millennium] (rev 01) (prog-if 00 [VGA])
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 10
Region 0: Memory at e4000000 (32-bit, non-prefetchable) [size=16K]
Region 1: Memory at e5000000 (32-bit, prefetchable) [size=8M]
Expansion ROM at e6000000 [disabled] [size=64K]
00:09.0 Ethernet controller: Accton Technology Corporation SMC2-1211TX
(rev 10)
Subsystem: Accton Technology Corporation: Unknown device 1211
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
Latency: 32 min, 64 max, 64 set
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at e800 [size=256]
Region 1: Memory at e7000000 (32-bit, non-prefetchable) [size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- AuxPwr- DSI- D1+ D2+ PME+
Status: D0 PME-Enable- DSel=0 DScale=0 PME+
Capabilities: [60] Vital Product Data
00:0a.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139
(rev 10)
Subsystem: Realtek Semiconductor Co., Ltd. RT8139
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
Latency: 32 min, 64 max, 64 set
Interrupt: pin A routed to IRQ 5
Region 0: I/O ports at ec00 [size=256]
Region 1: Memory at e7001000 (32-bit, non-prefetchable) [size=256]
CPU0
0: 146319 XT-PIC timer
1: 184 XT-PIC keyboard
2: 0 XT-PIC cascade
5: 1889 XT-PIC eth1
9: 0 XT-PIC soundblaster
11: 356 XT-PIC eth0
12: 0 XT-PIC PS/2 Mouse
14: 2026 XT-PIC ide0
15: 5 XT-PIC ide1
NMI: 0
ERR: 0
PCI bus 01 is an AGP bus, but there is no AGP video card present. eth1
does function, but the sound card does not. More information available
on request.
--Brian Gerst - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Feb 10 2001 - 12:01:24 EST