8139too bug in 2.4.4 (2.4.3?) & VIA 686a

From: Ignacio Monge (ignaciomonge@navegalia.com)
Date: Sun May 06 2001 - 02:49:55 EDT

  • Next message: Wayne Whitney: "Re: How to debug a 2.4.4 tulip problem?"

            Hi, here I again with another problem :)
            Since I have installed kenel 2.4.3 & 2.4.4 (nothing went wrong with
    default kernel in MDK 8, 2.4.3mdk), my ethernet card is not recognized
    correctly.

            This is my ifconfig output:
    eth0 Link encap:Ethernet HWaddr 00:E0:29:9A:CB:62
              inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
              UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
              RX packets:437 errors:0 dropped:0 overruns:0 frame:0
              TX packets:302 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:100
              RX bytes:70770 (69.1 Kb) TX bytes:222559 (217.3 Kb)
              Interrupt:11 Base address:0xc000

            The HWaddr is correctly (I'm using 2.4.3mdk actually). But, with
    2.4.3-2.4.4 this value is incorrect, and after a couple of minutes, kernel
    displays a message like this "Clock timer bug, may be a hardware bug VIA
    686a." After reboot linux, this BIOS setup has deleted (CMOS checksum
    error...), and the default values reloaded.

            I can't use another kernel than 2.4.3mdk.

            <Another interesting outputs:

            lspci -vv:
            [...
            00:0c.0 Ethernet controller: Accton Technology Corporation SMC2-1211TX
    (rev 10)
            Subsystem: Accton Technology Corporation EN-1207D Fast Ethernet Adapter
            Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
    Stepping- SERR- FastB2B-
            Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
    <MAbort- >SERR- <PERR-
            Latency: 32 (8000ns min, 16000ns max)
            Interrupt: pin A routed to IRQ 11
            Region 0: I/O ports at 9000 [size=256]
            Region 1: Memory at de800000 (32-bit, non-prefetchable) [size=256]
            Expansion ROM at <unassigned> [disabled] [size=64K]
            Capabilities: [50] Power Management version 2
                    Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA
    PME(D0+,D1+,D2+,D3hot+,D3cold+)
                    Status: D0 PME-Enable- DSel=0 DScale=0 PME+
            ...]

            dmesg:
            [...
    8139too Fast Ethernet driver 0.9.15c loaded
    PCI: Found IRQ 11 for device 00:0c.0
    eth0: SMC1211TX EZCard 10/100 (RealTek RTL8139) at 0xda88c000,
    00:e0:29:9a:cb:62, IRQ 11
    eth0: Identified 8139 chip type 'RTL-8139C'
    eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
    ...]

            I hope this may help.
            
            
            
            
    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at http://www.tux.org/lkml/



    This archive was generated by hypermail 2b29 : Sat May 05 2001 - 21:04:43 EDT